IEC 60745-2-5测试探针With φ35*5 Stop Face For Circular Saws Test

IEC 60745-2-5测试探针With φ35*5 Stop Face For Circular Saws Test

Test method:IEC60745-2-5 clause19.101.2.2 The upper guard on the side opposite the motor need not completely cover the blade. The perpendicular projection of the upper guard on to the blade shall cover at least the smallest recommended blade-cutting edge zone. The space between the upper guard and the blade shall be designed such that the test probe 'a' of Figure 105 when inserted at any angle and to the depth allowed by its stop, shall not be able to contact the saw blade teeth tips of the recommended blade, as illustrated in Figure 106.Test Finger Probe

Standard:IEC 60745-2-5 : Particular requirements for circular saws, clause 19.101.2 and Figure 105

Application:This probe is applicable to verify the upper guard protection against to touch the blade.

Test sample:电圆锯Test Finger Probe

Feature:Apertures in the guarding system above the guide plate, unless otherwise specified below, shall be designed such that the test probe ‘a’ of figure 105, when inserted at any angle and to the depth allowed by its stop, shall not be able to contact the cutting edge zone of any recommended blade.Test Finger Probe

Parameters:

1. Probe: diameter 12mm, length 50mm, R6 hemisphere end

2. Stop: diameter 35mm, thickness 5mm

3. Handle: diameter 8mm, length 30mmTest Finger Probe

Probe diameter	12mm
Probe length	50mm
Baffle diameter	35mm
Baffle thickness	5mm
Handle diameter	8mm
Handle length	30mmTest Finger Probe

Picture for reference: