IEC60669-1 IEC Test Equipment Self Ballast Lamp Load 3 Stations Box 300v Breaking Capacity

IEC60669-1 Self Ballast Lamp Load 3 Stations Box 300v Breaking Capacity And Normal Operation Life Test

Standard:IEC60669-1:2017 clause 19.3

Application:This device is suitable for breaking capacity and normal operation life test to fixed switches for house held and similar purpose, especially suitable for self ballast lamp switch electric stress and thermal stress test when control the LED circuit. To verify whether the switch can withstand normal use, any mechanical damage or electrical fatigue failure under normal operation, any contact adhesion phenomenon or long term closure or disconnection phenomenon, to test whether excessive wear or other harmful consequences.

测试样品：Self Ballast Lamp(SBL) Switches

Feature:Dimension about: wide (800mm) * Deep (800mm) * high (1800mm). The frame is blue and the side panels are light white. Above the front is the operation control panel. On the control there are power switch, product test voltage and power display instruments, alarms, touch screen, etc., there are resistors and capacitor load combinations, AC contactors, relays. There is a terminal under the box, which is connected to the product in the testing machine through the wire, and outputs current and provides load in the inspection process.

The load device has been preset with standard load conditions before shipment. As long as the test voltage is adjusted to 250V~, the operator presses the switch button with the same rated current as the switch to be tested, and its rated power, impulse waveform, I_顶峰和我²t meet the corresponding requirements of the standard.

There are 3 stations and 3 switches can be tested at the same time.

With metering mode and metering dedicated port, built-in 90-degree closing plate, easy to measure the output waveform, I_顶峰current value and I²t energy value, fully meet the standards for equipment measurement requirements.

The device is equipped with a voltage regulator, which can reach the voltage of 250V required by the switch test without the need of an external voltage regulator.

Parameters:

1. Power supply: single phase AC220V±5%/50Hz, power supply to test sample prepared by user.

2.电压计：范围0〜300V，精度0.5，数字显示

3. Power meter: 0~9KW, precision 0.5, digital display

4. Output channel: 3 channel

5.每个预设开关额定电压250V〜，额定电流10a，13a，16a，20a四个可选（可定制测试电压和测试电流）。

6.输入电压可调,确保the test voltage is 250V~

7. All operating parameters are set at 250V~, including W, I_顶峰, I²t，浪涌电流波形。

8.每个设备都提供了一个关闭控制装置（触摸屏选择“测量”功能），每次都处于90度角传导中，该功能可用于初始设备校准和测量验证。

9. With long / long protection function, the protection time of 1 ~ 99S can be preset, shutdown alarm protection.

10. Use environment: temperature 5 ~ 40 °C, relative humidity 20 ~ 90% RH, atmospheric pressure 80 ~ 106kpa. No severe vibration, no electromagnetic interference, no dust, corrosive gas, good heat dissipation.